filters
state:
Show
city:
Show
product:
Show
The design of this handle would work for either a front or angle mount, but it does not and cannot work for a side mount, which it also claims to be good for. The angle that the lever has to use is slightly under 45 degrees which, does not provide sufficient lift due...
Read more
#1272887
Reply to reviews
Show

Danco - Call just dropped?

I was trying to call Danko about a tub spout replacement
#1156856
Reply to reviews
Show

Danco 88103 Faucet Repair Kit Review

I bought danco repair kit # 88103 the seal's don't fit the Delta faucet leaks worse than it did before these kits are junk!!!!!!!
1.0
Details
Price Affordability
Staff
Value for money
Warranty
#991956
Reply to reviews
Danco faucet and plumbing repair parts. I have purchased three kits / replacement parts for my Ameriçan Standard kitchen sink faucet. All three have failed immediately. Installation is simple. These Danco replacement parts made in China fail every time. They leak,...
Read more
Anonymous
David

Personally, I too am mad as all get out.Just spent all day replacing this stem, hot water side, with two replacements.Still drips.Danco said they will answer my email as soon ...

Anonymous
Anonymous

I did contact Danco. They had no solution for my faucet dripping. No possible reason whatsoever. Nothing! They did send me 3 replacement valve stems. I already put the previou...

1.0
#767810
Reply to reviews

Goodbye Danco
Today, I finally came to the final stage of a bathroom I have been working on for several weeks. My last day on the job - pay day. The custom maple vanity cabinets divided by a slender linen closet, the floor tile and backsplashes are something I'm very proud of. ...
Read more
Anonymous
Wet but Hot

I had the same problem with the Danco Push Button Drain for sinks with overflow hole. I had purchased five sets for the sinks throughout the house on what was supposed to be a...

#421330
Reply to reviews

THE CAR WAS PURCHASED A 2003 NISSIAN WHICH COME TO FIND OUT THEY DID NOT EVEN DO THE EMISSIONS TESTING WHEN NEEDED FOR ONE TWO IT SHOULD HAVE NEVER BEEN SOLD. ENGINE PROBLEMS A MESS DANCO, THE CAR DOES NOT RUN AT ALL TOLD HIM HOW MUCH IT WOULD COST TO THEM THE CAR...
Read more
#289420
Reply to reviews
I have spent lots of time and money using the Danco perfect match hot/cold stem 3J-4H/C, for NIBCO/STREAMWAY stock # 16015B. I bought 5 of these faulty stems from Lowe's, installed them and every time they worked perfect for 7-10 days and then bam; shut it off and...
Read more
Anonymous
David

I just replaced mineI have been retrying parts for 3 hours now and can't get it to stop dripping.Stopped the orginal problem, running a stream, but tried two different kits, a...

Anonymous
Anonymous

Same issue. Danco products are not reliable. Stem 05950B is really has failed 5 times. At $24, this is getting very expensive. I have similar issue with another danco stem. ...

Wapakoneta, Ohio
#163708
Reply to reviews
Dear sir (s), I have purchased several Nibco/Streamway spigot stems over the past year ( stock #16015b hot/cold stem--3J-4 H/C by Danco. I am a repairman and would have problems with the cost of getting a plumber to install these stems because of the cost factor. I...
Read more
Anonymous
vman

i had the same issue after replacing stem. I removed it again and lightly sanded the seat and put a small layer. of teflon tape around the seat portion on the stem. Replaced...

Anonymous
melissa

We have had the same problem with these piece of *** stems. We even started buying them 3 or 4 at I time since we know they will not last.

#108624
Reply to reviews